SKU and Maximum QTY Reorder Policy

liners
liners Member Posts: 9
edited 2007-02-27 in NAV/Navision Classic Client
Hi !

I am having a problem with the results of the Requisition Worksheet.

I need to use SKU's and reorder policy Maximum Qty.

eg. Safety Stock Qty - 25
Reorder Point - 25
Maximum Inventory - 100

Qty on hand - 14

When I use the requisition worksheet and "calculate plan" the reorder amount is 100 units and it should be 86 (100 less 14).

I can not get it to work properly.

Do you have a suggestion ?????

Thanks!

Comments

  • nunomaia
    nunomaia Member Posts: 1,153
    From online Help
    In this field, you can enter a quantity that you want to use as a maximum inventory level. When calculating order proposal quantities, the program will then use maximum inventory minus the actual quantity available at the time of the order. Note that depending on the current inventory at the time, this may result in order proposal quantities that cause the projected available balance to exceed the maximum inventory that you define.

    Did you define correctly the dates in you planning?
    Nuno Maia

    Freelance Dynamics AX
    Blog : http://axnmaia.wordpress.com/
  • liners
    liners Member Posts: 9
    Thank you.......yes my dates are correct.

    I have just checked again and I can not make it work properly.

    Do you have any other suggestions?
  • nunomaia
    nunomaia Member Posts: 1,153
    Check Lead Time Calculation in Item Card.
    The Qty. on hand can be out of the safe lead time.

    That's why I have told you to check dates.
    Nuno Maia

    Freelance Dynamics AX
    Blog : http://axnmaia.wordpress.com/
  • liners
    liners Member Posts: 9
    I am not using lead times in the calculation. I will try to input a few different options, perhaps that is the problem.

    Thank you for trying to help.
  • nunomaia
    nunomaia Member Posts: 1,153
    Just one more question :)

    which Navision version are you using ?
    Nuno Maia

    Freelance Dynamics AX
    Blog : http://axnmaia.wordpress.com/
  • liners
    liners Member Posts: 9
    I am using Nav 4.0
  • nunomaia
    nunomaia Member Posts: 1,153
    I checked at partnersource and there is some hotfixes related to requisition worksheet in Microsoft Navision 4.0
    I advice you to check there.
    Nuno Maia

    Freelance Dynamics AX
    Blog : http://axnmaia.wordpress.com/
  • liners
    liners Member Posts: 9
    Thanks......I will have a look.

    :)
  • sonvdb
    sonvdb Member Posts: 33
    Hi Liners,

    You can do it by remove the number in Safety Stock field or set it less than Qty On Hand.

    Why do you use both Safety Stock and Recorder Point at the same time? What different here?

    Regards

Categories