OK button in BC

Gnol
Gnol Member Posts: 2
edited 2021-06-28 in NAV Three Tier
Hello,
I have an issue when running a page using runmodal = lookupok
The source of the page is a temporary table
And when this table is empty the OK button is disabled
uzk5ny0cjwkg.png

Is there any way to enable it?

Answers

  • RockWithNAV
    RockWithNAV Member Posts: 1,184
    When its empty, How come it makes a difference either its enable or not? you have cancel button to close it
    Thanks

    Blog - rockwithnav.wordpress.com/
    Twitter - https://twitter.com/RockwithNav
    Facebook - https://facebook.com/rockwithnav/
  • Gnol
    Gnol Member Posts: 2
    edited 2021-06-29
    RockWithNAV wrote: »
    When its empty, How come it makes a difference either its enable or not? you have cancel button to close it

    There is a check 
    If CloseAction = CloseAction::LookupOK then
    do something
else
    cancel the process
    In this case this is a page that shows records with problems, if there is no problem records it should be possible to press ok and continue the scenario.
  • azharsaeedkhan
    azharsaeedkhan Member Posts: 37
    edited 2021-07-26
    You cannot enable the OK button if there are no records.

    But a slight change to your logic can make it work fine 
    If CloseAction = CloseAction::LookupOK then
  If not Record.IsEmpty then    
    do something
else
    cancel the process
    Gnol wrote: »
    RockWithNAV wrote: »
    When its empty, How come it makes a difference either its enable or not? you have cancel button to close it

    There is a check 
    If CloseAction = CloseAction::LookupOK then
    do something
else
    cancel the process
    In this case this is a page that shows records with problems, if there is no problem records it should be possible to press ok and continue the scenario.

Categories