Invalid Cost Per Unit

Ah_Kit · 2008-12-15

Hi All,

At the Value Entries, I found the Cost Per Unit jump to 712++ due to unknown reason.

Eventhought, I perform the ACIE batch job and it was not fix the problem.

Anyone got idea about this issue and how to fix it ?

Thank you.

Regards
Liau

DaveT · 2008-12-15

Hi Liau,

Can be a number of reasons - you should look at the value entry table to see. The most common is a positive adjustment with an incorrect cost.

Alex_Chow · 2008-12-15

Ah Kit wrote:

At the Value Entries, I found the Cost Per Unit jump to 712++ due to unknown reason.

The reason must be known before you can being to address the problem. Go through the item ledger and value entry table line by line for this item until you can isolate the transaction in question.

Tcrawford · 2009-01-08

I dont know if this has been resolved. But i recently ran into this problem, Ours was the inventory in a particular location was negative, once we entered a journal to adjust the quantity and ran the adjust cost the unit cost as correct.

Invalid Cost Per Unit

Comments

Categories