Two columns in a CardPart?

tomddlc

Hi guys,

Hopefully someone out there can help...

When I create a Card page and add fields to a group, they show up nice in two columns. If I then add a part with fields from another table, these fields are always rendered in a single column - which isn't very nice to look at. I would very much like my "sub-part" to look like the other groups - is that possible?

Best regards
Tom

Troubles_In_Paradise

tomddlc wrote:

Hi guys,

Hopefully someone out there can help...

When I create a Card page and add fields to a group, they show up nice in two columns. If I then add a part with fields from another table, these fields are always rendered in a single column - which isn't very nice to look at. I would very much like my "sub-part" to look like the other groups - is that possible?

Best regards
Tom

I think that type cardpart was built to be used only as a factbox (afaik I've never seen a cardpart not used as a factbox in standard). because of this controls are rendered in one column.
have you tried with FixedLayout group?
(rembember that controls in a FixedLayout are always not editable)

tomddlc

I need the fields to be editable, so I'll have to try another design...

But thank you for your time