Dimension problem

madalinap

I have the following problem...
When introducing dimensions in General Journal,in the journal lines(using Shortcut Dimension Code 1 and Shortcut Dimension Code 2),sometimes it coppies the dimensions into the Journal Line Dimension,sometimes not!
Can somebody tell me what to do?
I heard about about a hotfix who solves this problem but i dont't know it number.So ,it will be good if somebody can tell me the number !


Thank you very much!

bostjanl

madalinap wrote:

I have the following problem...
When introducing dimensions in General Journal,in the journal lines(using Shortcut Dimension Code 1 and Shortcut Dimension Code 2),sometimes it coppies the dimensions into the Journal Line Dimension,sometimes not!
Can somebody tell me what to do?
I heard about about a hotfix who solves this problem but i dont't know it number.So ,it will be good if somebody can tell me the number !


Thank you very much!

Do you use VALIDATE to fill the shortcuts?


BostjanL

madalinap

You see,this VALIDATE is allready used in code !
if you look at the OnValidate trigger of this shortcuts there is a function which do this ,and then when the OnInsert tigger of the table is called, the values are inserted in the Journal Line Dimension.This must actually work but i don't know why sometimes it doesn't work!

Thank you anyway!

mstallmann

I have a client that is experiencing the same problem....Did you find a resolution to this?

Thanks in advance,

Mike