matrix resize and glue problem

Reinhard

Hello,

I have a form with a matrix on it.
It is glued to both sides vertically and horizontally.

When I expand the form, the matrix expands, as expected.
When I shrink the form, the matrix does not shrink vertically.

Any ideas?

- Reinhard

Shonatina

Do you mean minimizing by shrinking?

i have a matrix form too and its getting minimized but the problem 'm facing is that the horizontal scroll bar isnt working. if i need to see all the columns in the matrix form then i need to use tab.
Are you facing the same problem?

Thanks

Savatage

did you try following the hotw-to:
http://www.mibuso.com/howtoinfo.asp?FileID=13

Reinhard

Hi there, thanks for the reply.

Yes, actually this is my first matrix and I was using that how-to. It is very helpful.

Reinhard

Shonatina,

By shrinking I mean grabbing either the bottom edge, or bottom corner, and dragging towards the center of the form.
Resizing may be a more accurate term.

Shonatina

@ Reinhard

hi..
oh so your problem is solved huh?

mine is that i dont see any horizontal scroll bar in my matrix form. i need to use TAB to move from 1 rec to another.

Do you why this is happening?

Tanks

Reinhard

hmm, no I don't know.

to clarify my problem has not been solved. when I resize the form and make it smaller, the matrix edges remain where they are, as if it had reached its minimum size.

- Reinhard

Savatage

All mine are like that too.

If the form is maximized I don't even see the horizontal bar.
If I don't maximize it, I see the bar but it's of no use.

Tab is the way to go.

Shonatina

oh then its the standard procedure? no solution for that? because i have create a matrix form with more then 100 rec...imagine going through all with TAB.

Shonatina

i have no problem with resizing...i can minimize or maximize. drag the sides along. it works fine. my only problem is thehorizontal scroll bar isnt working.