Working with Break Point under Navision 3.70

Chino22

Hi there,

Any of you please can tell me how to use the break points in Navision 3.70
I put it to a line, there is a big full-red circle, but the running process would not stop at the break point. And there is an other red circle with a hole, WHAT IS THAT FOR? :oops: :oops:

I know this is a lame question, but I could not figure it out!

Thanks for all of you, who help me

Luc_VanDyck

You first set the breakpoint using F9 in the C/AL Code, then you set the debugger active using Tools -> Debugger -> Active. Make sure the second option (Breakpoint on Triggers is NOT set). Then run your code. The debugger will now show up when it comes at your breakpoint.