In General Ledger Setup, when I attemped to change the "Inv. Rounding Precision" from 1 to 0.01, an error prompted.
I found that it was because the field "Amount Rounding Precision" was 1, so the change was denied.
"Amount Rounding Precision" is not appeared in the FORM, so I have to change it directly at the "General Ledger Setup" table in Object Designer.
What should be the correct procedure to change the "Amount Rounding Precision" ?
P.S. In my setting, the "LCY Code" field is blank.
0
Comments
One Business Solutions Inc.
WI, USA.