Hi Master,
I want to print label using continuous paper. size of paper 153cm(height) x 102cm(width). after reaching 153 cm,there is a "line" for tear off. there is 4 label in 1 page(153x102). The problem is there is a gap(blank line) and printer still continuous printing in "line". What I have done :
1. I try to make new form (server properties) regard to 153x102cm but I can not find it in page setup
2. to make it no blank space before and after new page, I make bottom margin properties = 0 but there is still blank space in bottom of paper.
What should I have to do?
rgds.,
Angelo
0
Comments
The blank margin, can be caused by the way you do the report. By any chance you have any where in the section 'CurrReport.SHOWOUTPUT := FALSE'? This may cause the problem.
Setting a custom paper is always a challenge. Hang in there, I've done this to a few customers - with success, after a lot trial and error. (printer was either LX300 or LQ680)
Not to mention if you the user is in Terminal Service environment #-o
Rgds,
Jon.
Jon.