How to get back to Report Designer

nmonty
nmonty Member Posts: 20
edited 2007-07-30 in NAV/Navision Classic Client
Actually I want to know that when I run the Report Then I have to give filters then I preview the report. After seeing the report I press Escape Key,now Again I hav to Run the Report but I want a way that after pressing escape i must go in the form where I give the filters.

Rite Now I m using Nav 3.70


Thanks in advance

Answers

  • Administrator
    Administrator Member, Moderator, Administrator Posts: 2,508
    Please change your topic title, according to forum rule #7
  • fl
    fl Member Posts: 184
    Impossible !!! :(

    The form you look at for placing the filter is the requestform of the report. This form can only be shown again by running the report again. You could solve this in the code that is starting the report. But how will you ever find a way to exit that loop then.

    So to keep it simple, IMPOSSIBLE.
    Francois
    Consultant-Developper

    http://www.CreaChain.com
  • nmonty
    nmonty Member Posts: 20
    Thanks...But can u tell me to how to reach to that code...
  • fl
    fl Member Posts: 184
    There is no accessible code that runs this form. This is done automatically by the navision .exe file if the client starts a report. Yes, you can hide tablefilters, and the requestform and so on by properties, but you can not access the code that fires afterwards the report itself because this code is in the .exe file. Use the debugger and run a report, you will see which code is accessible.
    Francois
    Consultant-Developper

    http://www.CreaChain.com
  • nmonty
    nmonty Member Posts: 20
    Thanx again for the reply...but there should be a way out or is it IMPOSSIBLE....Can I not access the code of fin.exe.....
  • fl
    fl Member Posts: 184
    It is IMPOSSIBLE.

    You can not view/edit/change the code of the fin.exe [-X

    :(
    Francois
    Consultant-Developper

    http://www.CreaChain.com

Categories