Hold The Value In A Variable

ricky76 · 2006-09-11

Hello,

I was wondering if someone could help me. I have a work in progress report that reports on what the current situation within the company is. This report outputs into a weekly grid. When this is run on a Monday for example it populates loads of different variables. I want the report to hold the value of these variables until it meets certain conditions within the report at which time i will reset it. For example if the value of a Monday variable was 100 i don't want to reset this variable until the following week. On the Tuesday i want the Monday variable to still hold the value of 100. At the moment the variable resets itself everytime the report is run therefore i would have the correct information for Tuesday but Monday would say 0. Is want i need to do possible? Any help would be much appreciated.

andreof · 2006-09-11

Hello,

Have you considered using a table to hold the values?

Regards

ricky76 · 2006-09-11

I did think this may be my only option but was hoping to avoid this to be honest

nunomaia · 2006-09-11

You can store those values in a XML File, a TXT.

But you will complicate a simple solution. The best way is to store that info in a table.

Every time the user closed Navision Client, the Variables are cleaned

ricky76 · 2006-09-12

Thanks very much for your help. I think i will go down this route on putting the values in a table.

Hold The Value In A Variable

Comments

Categories