RDLC Report not running after adding a boolean to the request page

p0wertube · 2018-10-01

I'm writing a report to analyze customer credit lines.

I added a CAL GLOBAL (Boolean) and put it in the request open page designer.
Now the NAV Client crashs, when i try to run the report. As the request page will not be shown, I think that there is an problem with the request page..

Agannalo · 2018-10-01

Did You check "IncludeInDataset" property to Boolean value?

thomas_barbut · 2018-10-01

Hello,

If client Crashes have a look at Event Viewer on service tier. Paste the event message here so we can help you debug.

best regards,
Thomas Barbut

Agannalo · 2018-10-01

Did You check "IncludeInDataset" property to Boolean value?

p0wertube · 2018-10-01

Value was on "no", I switched it to yes, but that didn't helped.

thomas_barbut · 2018-10-01

Hello,

If client Crashes have a look at Event Viewer on service tier. Paste the event message here so we can help you debug.

best regards,
Thomas Barbut

p0wertube · 2018-10-08

Thanks Thomas, found out that only my Client was crashing when running the report, no Problems on other Clients.

After starting the nav repair Job, the report is also running on my Client.

RDLC Report not running after adding a boolean to the request page

Best Answers

Answers

Categories