Autocad Automation

mplatvoet
mplatvoet Member Posts: 34
edited 2002-03-20 in Download section
Hello,
We are trying to connect AutoCad 2000 with Navision by using automation.

When trying to draw a line, using the command acApp.application.modelspace.addline(start,end) I cannot figure out what I have to put into start and endpoint. The system requires for both points an X, Y and Z value. In VB you can use a three dimensional array, but in Navision I doesn't work out. Can anybody help me?

Comments

  • Administrator
    Administrator Member, Moderator, Administrator Posts: 2,506
    Topic moved from Download Section to Navision Financials.

    <small>[ 20-03-2002, 16:48: Message edited by: Moderator ]</small>

Categories