Reporting, Order Confirmation (204) & qty of pages

northyen
northyen Member Posts: 14
edited 2013-06-27 in NAV Three Tier
I'm trying to get a better understanding of how exactly the reporting design works, with all its quirks. Currently I have an issue about a second page being added, even though the body of that page is empty. My experience in this RDLC is a couple of hours.

I restarted the design and figured out, it is caused by removing the SalesOrderDim Tabilx at the very bottom of the page. As soon as I delete that, it always prints out two pages. However I don't understand why this happens. I think it might be connected to how the page breaks are generated after a group is finished. But that's just a guess.

So, any ideas on why this happens?

Comments

  • geordie
    geordie Member Posts: 655
    Second pages could appear also because the width of the table is greater than the width of the page...
    * Daniele Rebussi * | * Rebu NAV Diary *
  • northyen
    northyen Member Posts: 14
    Thanks for the answer, however, I do not believe this is the case for this report.

    The single only thing I did, was removing the Tablix from the page, so I don't see how this is connected to the width of the page?

Categories