rounding off error in Transfer oder

kranthi
kranthi Member Posts: 72
edited 2009-02-23 in Dynamics AX
I am working on ax 4.0 sp2 .
general round off set to "0".
I am using only one curreny "INR".

During the shipment of the Transfer order i am getting an error.

"Error in unit of currency. must be rounded to zero"
"Unit of -199.82 -199.82 being posted to account is too little".

I tried by changing the Maximum Penny difference but it didn't worked.
I am unable to find out the cause of this error.

Any help will be appreciated.
Kranthi

Comments

  • AdamRoue
    AdamRoue Member Posts: 1,283
    It all comes down to currency and something odd on one of the lines

    When the transfer order shipment is posted, the code has a look at the standard cost of the product vs the posted cost on the inventtrans record for an item which could be:

    Standard Cost : 1809.08
    Posted Cost : 1809.075484875124

    It then attempts the profit/loss posting which is an amount of - 0.004515124876
    Rounded this equates to 0.00 which is less than the general amount rounding of 0.01 in currency … at this point in time it gives up and throws a whole lot of errors.

    It also attempts to post reversing transactions for these entries, but once again, fails due to the rounding issue.

    I got the developers to write a code fix for this, so you will either need to do the same or report it to Microsoft who may have a fix.
    The art of teaching is clarity and the art of learning is to listen

Categories