Newbie: Shipment-Report

Kromozone · 2004-10-07

Hi Navision-Specialists,

I've written a Interface to a Parcel-System. I want to run it when the System created a Shipment-Report to transfer the data to the Shipping-System.

I've searched a good place at Codeunit 80, but for me (one month in navision) it's a bit confusing

:roll:

How must I write down my code to run it every time the System creates an Shipment-Report?

Thank you!

Regards
Andy

Pat · 2004-10-07

Search in Codeunit 80 for // Insert shipment header

Another possibility is the OnInsert-Trigger of the table Sales Shipment Header.

Kromozone · 2004-10-07

Thank you, I will try it!

Andy

Kromozone · 2004-10-07

At this Position (// Insert shipment header), the Header is available, but the Lines have not been written into the database. I need the Information from "Sales Shipment Line"

Pat · 2004-10-07

Search for // Insert shipment line in C80.

If you want to put your code in the OnInsert-Trigger of the table Sales Shipment Line, you have also to change in C80 in the trigger OnRun the part SalesShptLine.INSERT into SalesShptLine.INSERT(TRUE).

Kromozone · 2004-10-08

:oops: Arrgh... ich tried some Positions in C80 "// Insert shipment line in C80", but i could not find one that runs only one time for each Shipment-Report. I only want to run my Functions one time after the Report is finished

Thank you in advance
Andy

Luc_VanDyck · 2004-10-08

Here is another approach: keep track of the Shipment No's that are created in CU80 by storing them in a table. After the posting routine has finished, you can loop through that table to find the created shipment info, and update your Parcel System. This way, the only modification needed in CU80 is the code to store the Shipment No's.

Newbie: Shipment-Report

Comments

Categories